H@nk wrote:Wondering whats the minimum thickness of the plywood?
Wondering, could this table being made for just two seats?
Henk
The plans are on the way ...
I designed it for 3/4" ply, thinner may be possible, but I haven't tried it. Just modify all of the lap joints to reflect a slightly loose slip-fit for your material thickness.
Two seats would be easy, just cut the seat supports in two at about 3" off center to leave the center notch intact and only cut out two seat legs and seats, however, realize that some of the strength of the table is derived from the seat assemblies (they keep the table legs from buckling sideways if a twisting load is applied to the table top.) You are more than welcome to modify as you see fit and let us know how it worked out (new ideas can improve any design.)