Hey everyone
Started my build over the last few weekends using the Northern Tool 5x8 trailer. I built the floor using 1/2inch ply and 1x2 as a box frame sandwich with insulation in between. I cut out holes for each of the bolt heads that sit on top of the trailer frame.
Question is - the floor isnt sitting exactly square on the trailer frame. It seems my floor is square but perhaps the trailer is off - i have overhang by roughly .5" on two opposite corners. Has this been a problem for anyone else? My sides are going over the frame so I can probably hide it but not sure if this is going to cause major issues after I bolt it down. Any advice is appreciated!