Hello everyone,
Posted in here a couple days ago and got some very prompt help. I'm hoping for the same. I'm running a very simple electrical system that is essentially like the post from Joanne on this page. 110 AH battery to master fuse/switch to Parallax circuit board to some outlets, a fan, and some dome lights. I was checking everything to make sure I understood how things worked and I wired it properly. Connected the fuse and the wires to the dome light. Connected the dome light. Success. Did this a couple different times as I checked out a few of the different outlets. Everything looked good. I went to permanently set it up just now and got it working. Went to connect the wires to the dome light and forgot the connectors. Went, grabbed connectors, and the whole system shut down. I can get the light to work if I just tap them to the battery tops. Same thing with the end of the battery wires that would be connected to the circuit board. But when I tap them on the circuit board to check there, I get no juice. I've tried using fresh wire, setting it up a few times, and I'm absolutely stuck. I can't get any sort of electricity from the circuit board whereas half an hour ago it was working just fine. Any thoughts? Preciate the help.