Hi Dave,
did a time served apprenticeship in sheet metalwork & fabrication.
also built various bits & pieces for the off-shore, aircraft & petro-chemical
industry before becoming a train driver 9 years ago.
hope the previous knowlage & use of this forum will see me through.
must say Angib's CAD skills are makeing it possible.
also a friend of mine has a very well equiped workshop, lets me use it &
the overtime has dropped off at work.
the wife is somewhat dubious of it all. puts up with alot, bless.
will attempt to do a time-laps series of images of the build from the same camera angle, it may work.
anyway the first stage is to make a profiled buck of the door opening so
i can beat an inward return flange into the skin.
may start it monday.
all the best, dan.