DMcCam wrote:Hi Everyone,
We fixed a few things this weekend. The doors needed another 1/8" spacer on the wall side of the hinges for the seal to seat correctly. Once those were in place the doors sealed nice and tight. I made the offset blocks for the interior handle/latches and installed them. With the cabin sealing, we felt it was time to put the mattress inside! We got to finally close the doors and lie down on our new bed, what a nice milestone!
Here a shot of the driver's side all closed up.
With the door open you can see how the 'D' rubber seal fits into the 'T' molding.
First look at the almost finished interior. We still have to install the curtains, make then install the door skirts and trim off the long tails of the exterior door handles flush with the interior latches.
Here's how the aft area is shaping up. I found some 1/2" vinyl closed cell weather seal at Ace Hardware for the inner door seal. We'll install that on Wednesday.
All the best,
Dave
Dave, on the 2nd photo, what did you use for the latching system? I looked up the outside handles, from So-Cal speed shop, but wandering if you could let me know what components were used on the latch system, and also where you got the hinges. Thanks so much. Caleb.