Re: Foamie cabinets
Posted: Wed Nov 28, 2018 10:43 am
I would imagine a prime coat would be best. I would let that dry then do the wet embedding with the fiber mat. Then do a top coat. Also, his overwrap the edges with the mat and decoupage system which should tie it all together, not just side panels where edges easily peel off laminate layers. The other big issue I would see is if the unit went under a lot of flexing weakening the interface area causing delamination. I have not done one of these yet, but I would imagine the polyurethane impregnating also helps to solidify the unit. I have never used gripper, but Zinsser Bullseye is my primer of choice as I have seen it dry in puddles to a tough and hard material and will be using that on my build. Hope that helps!