Have any of you turned the spring binder bolt around... specifically on the N. Tool Ironton 5x8? I am hoping to build with spring above the axle and hope when I try to remove the bolt it is not pressed in. If it is pressed in is it a bugger to remove/re-install backwards?
Some details... the axle is straight/flat, I don't care about the U Channel being up-side-down (open on top if reversed), the nut doesn't appear to be "locked on" the bolt in any way (no locktite compound visible, no pings in the side of the nut or on the bottom face of the bolt at the nut)
Thanks,
Tim
Manufactured position