I'm installing a fridge on drawer slides in the galley of my new Foamie build. I want to provide some ventilation and after reading past tnttt posts on the subject I am wondering if the following method might eliminate some of the road dust that might enter through the vent.
I'm thinking of a 2" PVC Street EL placed below the fridge, through the floor and pointing toward the rear. It would be accessible enough to be able to cap off the end with a 2" test plug which I see Menards has for seven bucks.
I'll probably install a small case fan over the vent and figure out which wire in the control wiring is hot only during the fridge run cycle. Not sure there is such a thing but if there is I'll find it.
Whatdayathink?