dh wrote:I went with the hydraulic fitting for two reasons. First, its what I had laying around the shop, second, I think it has a cleaner look than a black iron street elbow.
dh wrote:I'll have to look closer at it. Would brass be an acceptable substitute? Anything funky about flare fittings I should know? I ''barrowed'' a brass male flare fitting from work to go from the hose to the pipe. We use them for slide core water fittings on injection molds at my night job.
bdosborn wrote:So what kind of hose do you use for gas appliances inside a trailer?
Bruce
madjack wrote:dh, black pipe was always the preferred product because(supposedly) zinc can flake off of galvanized and stop up the orifices of your appliances...some codes say yay and some say nay...in my experience, I have never come across an orifice stopped up from zinc flakes..............
madjack
Shadow Catcher wrote:I used 3/8 copper from the POL fitting in the front to the flare fittings in the rear
Return to Plumbing & Propane Secrets
Users browsing this forum: No registered users and 4 guests