(0233) I welded the lower factory triangle to the tongue extension. I cut the coupler mounting "BOX" off of the top triangle & flipped i
(0244) The rear of the extension in primer. You can see the way I attached it to the cross members. The mounting holes line up with pre-existing holes
(0243) The front of the extension after I sanded the mill scale off of it and primed it.
(0235) The HF coupler is 2 1/2" wide so it bolted right to the extension after I drilled holes to match the holes in the coupler.
(0233) I welded the lower factory triangle to the tongue extension. I cut the coupler mounting "BOX" off of the top triangle & flipped i
(0234) I attached it two the first two cross members & the added center cross member I installed earlier.
(0232) Another view of the added steel. It is a piece of 2 1/2" by 2 1/2" .120 wall thick square tube.
(0231) I wanted to reinforce the tongue. It seemed very flimsy. I got this idea from synaps3. Thanks Dave. I made it 2' longer and reused the HF coupl
down under tech

(0233) I welded the lower factory triangle to the tongue extension. I cut the coupler mounting "BOX" off of the top triangle & flipped i

There are no comments to display.

Photo information

Category
TnTTT Members Gallery
Album
down under tech
Added by
down under tech
Date added
View count
347
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Try RV LIFE Pro Free for 7 Days

  • New Ad-Free experience on this RV LIFE Community.
  • Plan the best RV Safe travel with RV LIFE Trip Wizard.
  • Navigate with our RV Safe GPS mobile app.
  • and much more...
Try RV LIFE Pro Today
Back
Top Bottom