(0243) The front of the extension after I sanded the mill scale off of it and primed it.
(0247) This view shows how I made a place to attach it to center cross member
(0239) The top triangle afer I cut the "BOX" off of it. I sanded the cut areas and primed it. I then flipped it over and it helps hold the e
(0244) The rear of the extension in primer. You can see the way I attached it to the cross members. The mounting holes line up with pre-existing holes
(0243) The front of the extension after I sanded the mill scale off of it and primed it.
(0235) The HF coupler is 2 1/2" wide so it bolted right to the extension after I drilled holes to match the holes in the coupler.
(0233) I welded the lower factory triangle to the tongue extension. I cut the coupler mounting "BOX" off of the top triangle & flipped i
(0234) I attached it two the first two cross members & the added center cross member I installed earlier.
down under tech

(0243) The front of the extension after I sanded the mill scale off of it and primed it.

There are no comments to display.

Photo information

Category
TnTTT Members Gallery
Album
down under tech
Added by
down under tech
Date added
View count
397
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Try RV LIFE Pro Free for 7 Days

  • New Ad-Free experience on this RV LIFE Community.
  • Plan the best RV Safe travel with RV LIFE Trip Wizard.
  • Navigate with our RV Safe GPS mobile app.
  • and much more...
Try RV LIFE Pro Today
Back
Top Bottom