Danny 
Teardrops n Tiny Travel Trailersor t n ttt for short (tnttt.com) |
homemade jack stands
17 posts
• Page 2 of 2 • 1, 2
by halfdome, Danny » Wed May 16, 2007 8:52 am
I'd like to see what some of you would come up with as I tried a pair of these worthless jack stands and returned them. I could still rock the TD since that nut just sits on the stands, they just pitch in & out. Danny
Danny "Conditions are never just right. People who delay action until all factors are favorable do nothing". William Feather
Don't accept "It's Good Enough" build to the best of your abilities.
Teardroppers Of Oregon & Washington
-
halfdome, Danny - *Happy Camper
- Posts: 5894
- Images: 252
- Joined: Sun Aug 14, 2005 11:02 pm
- Location: Washington , Pew-al-up
by Mini Renegade » Wed May 16, 2007 10:38 am
hi guys, i`m currently experimenting with a pair of drop down type clamped stabilisers that i have mounted in-board at the rear.These are normally used on car transporter trailers to steady it when car is being loaded onto it, they weigh about 2 pounds each.
They are simply lowered by loosening the clamp and dropped down before retightening so are pretty much adjustable to any height. All that is left is to wind up the jockey wheel a bit to press em down.
They are simply lowered by loosening the clamp and dropped down before retightening so are pretty much adjustable to any height. All that is left is to wind up the jockey wheel a bit to press em down.
If evvr tha dus owt fr nowt, allus do it fr thissen
-
Mini Renegade - 500 Club
- Posts: 520
- Joined: Tue May 15, 2007 2:26 pm
- Location: (Old) York