alumunum t-molding for 23/32 plywood????

[aquaholic14]

I keep finding 3/4 t-molding for edging plywood, but cant seem to find the 23/32. Does anybody know where I can find some, or should just use the 3/4. Will the extra 1/16 cause a little lip on my ply??

thanks,
chad

[halfdome, Danny]

Glue on a strip of plastic laminate (Formica/plam) on your 23/32" plywood to fill the gap. Danny

[Airspeed]

You could just trim the T moulding down, it cuts easy on a tablesaw or bandsaw. Aaron

[doug hodder]

The difference is 1/32"...I'd just hit it with a good mill file to take it down, and a quick pass with some 400grit to smooth it. Just an idea. Doug

[Nitetimes]

The difference is 1/32"...I'd just hit it with a good mill file to take it down, and a quick pass with some 400grit to smooth it. Just an idea. Doug

And angle grinder with an aluminum flapper disc on it will do both in one pass, quick too!!