All steel framing

[Erik-the-red]

I had a local metal fabrication shop bend my 1 x 1 inch square tubing. They bent five pieces, which included the tubing stock, for $75.

[Keith]

Take a look at page 4 of Sumner's web site. He used 1/8 X 1" strap to form the sides of his trailer. We considered doing that but we decided to use 1X1 because it was easier for us to shape the sides.

http://purplesagetradingpost.com/sumner/teardrop/teardrop4.html

Keith

[emiller]

where did you get the manual ring roller or is it home made? been looking for one for several years now, or the plans. Denny

Here is where I got mine http://www.tuberoller.com/products/tubingbender.html

[Jiminsav]

there was some boys from the old forum that made all steel trailers, they looked pretty good too, I think they were from Wisconsin or close to it.