Hurricane Hinge Orientation

[KenC]

Hi all,

Quick question,

Is the orientation for the hinge shown in my photo below correct, I just got this from Grant today ( thanks Grant) and want to make sure I'm installing it the correct way. Also what is best to use between the bottom of the hinge and the spar, ply/ roof ? I'm thinking stainless steel screws and butyl tape or is something else better and will prevent water leakage / damage. Like locktite PL 2000 or something similar.

[rainjer]

You have it backwards.

Jeremy

[grant whipp]

Yep ... you've got it backwards, Ken!

Also, I use RV Putty Tape (black of grey) under the body side of the hinge and siliconized caulk under the hatch side. If you use stainless steel screws, pre-install with zinc-plated screws 1/4" shorter than your desired full length, then go back and replace with the ss screws ... ss screws won't drive start-to-finish without stripping the head or snapping off.

Continued Good Luck, and as always ...

CHEERS!

Grant

[KenC]

Thanks guys,,

Glad I asked. It makes sense now.

[H-Balm]

You may have felt silly for asking.... but you just made my life easier!

Thanks for that question, I have learned something!