Teardrops n Tiny Travel Trailersor t n ttt for short (tnttt.com) |
Which pocket hole jig?
19 posts
• Page 2 of 2 • 1, 2
by Postal_Dave » Tue Oct 11, 2011 6:52 am
I used the Kreg Jr and I've learned to use caution with it. The commercials show an easy 90 degree angle every time, but some times that's just not the case. When using 2 pocket screws on a little wall stud, I tighten the right screw first then the left screw, the stud leans a little to the right. It may even lean a little to the front also. Be sure to use a square to guide you when using a Kreg jig, and some good clamps.
Never argue with an idiot. They will bring you down to their level and beat you with experience.
-
Postal_Dave - Teardrop Master
- Posts: 168
- Images: 73
- Joined: Thu Jul 08, 2010 11:59 am
- Location: Upstate South Carolina
by CarlLaFong » Tue Oct 11, 2011 9:54 am
I bought some of these clamps. They really help when assembling a face frame or other project where a nice, precision joint is desired. Rockler sells them
http://jkcallin.blogspot.com/
"As I wandered, alone, through the endless fields of corn, I could hear the crows. They seemed to mock me, calling out my name, over and over", said Cawe
"As I wandered, alone, through the endless fields of corn, I could hear the crows. They seemed to mock me, calling out my name, over and over", said Cawe
-
CarlLaFong - 500 Club
- Posts: 701
- Images: 5
- Joined: Wed Jul 06, 2011 9:51 pm
- Location: Sunny SoCal
