Delaminating Ply!
18 posts
• Page 2 of 2 • 1, 2
by Bandit » Tue Nov 21, 2006 7:07 pm
Sorry for the duplicate!
Last edited by Bandit on Tue Nov 21, 2006 7:08 pm, edited 1 time in total.
First Metal Cut 02/11/06
Complete! (Almost) 08/22/06
Looking for a trip in the SPRING!!!!
Not Up to Testing the Heater!!!
Thanks for all the HELP!!!!
Complete! (Almost) 08/22/06
Looking for a trip in the SPRING!!!!
Not Up to Testing the Heater!!!
Thanks for all the HELP!!!!
-
Bandit - Donating Member
- Posts: 207
- Joined: Tue Dec 06, 2005 12:25 pm
- Location: McMinnville, TN
by Bandit » Tue Nov 21, 2006 7:07 pm
I used the Rot Doctor 255 I believe. It may have sealed the wood and the gassing affect may be to blame.
All edges were sealed so I do not think that there is moisture entering from the edges.
If it does not get any worse, I will probably live with it.
Worst case scenario, I rebuild the doors, not a big problem.
Thanks for all the replies, serious and joking.
I love a good laugh, you were laughing with me and not at me, right?
All edges were sealed so I do not think that there is moisture entering from the edges.
If it does not get any worse, I will probably live with it.
Worst case scenario, I rebuild the doors, not a big problem.
Thanks for all the replies, serious and joking.
I love a good laugh, you were laughing with me and not at me, right?
First Metal Cut 02/11/06
Complete! (Almost) 08/22/06
Looking for a trip in the SPRING!!!!
Not Up to Testing the Heater!!!
Thanks for all the HELP!!!!
Complete! (Almost) 08/22/06
Looking for a trip in the SPRING!!!!
Not Up to Testing the Heater!!!
Thanks for all the HELP!!!!
-
Bandit - Donating Member
- Posts: 207
- Joined: Tue Dec 06, 2005 12:25 pm
- Location: McMinnville, TN
with you
