Teardrops n Tiny Travel Trailers

Posted: **Sun Nov 01, 2020 10:26 am**

If it only fit on 10'

I'm not quite sure what you mean, but those files are for a cabin that fits on a 10' long frame. But cut from 8' sheets of plywood.

Tony

Posted: **Sun Nov 01, 2020 11:12 am**

10' +inches total. Just inches over a 10ft table with 10 ft sheets, Like I say I won't build one under 10 either. I want 11, it is one foo-tits.

Posted: **Sun Nov 01, 2020 11:24 am**

Twisted:

Just inches over a 10ft table with 10 ft sheets,

Those files are for a 126" long cabin cut on an 8' table (The rear curls back into 10'). The skeleton is joined by a spline joint.

And the joint is sheathed over with the skins.

Tony

Posted: **Sun Nov 01, 2020 11:46 am**

tony.latham wrote:
One last question on this topic: is there a benefit to using 1/8" ply over the roof insulation before skinning in aluminum? Given the spars and loading directions, it seems like you don't need the additional strength that you get from sandwiching the walls.

My roof systems start out with an 1/8" Baltic birch headliner, 2" spars and 2" of foam board, topped off with another layer of 1/8" Baltic. It's all glued together of course and the system becomes a torsion box just like the walls (but stronger since it's 2-1/4" thick).

It's stiff. I could probably stand on it. But without that top layer, it wouldn't be nearly as strong.

Tony

Yup.

From page 50 of the ShopManual

Sent from my iPhone using Tapatalk

Teardrops n Tiny Travel Trailers

Wall profile; outside plywood necessary?

Re: Wall profile; outside plywood necessary?

Re: Wall profile; outside plywood necessary?

Re: Wall profile; outside plywood necessary?

Re: Wall profile; outside plywood necessary?