Page 1 of 1
Generic Benroy Plans
Posted:
Wed Dec 13, 2006 12:55 pmby War Eagle
On page 17 of the Generic Benroy Plans I can see the starting/ pivot point for the rear 19 and 48 inch radius' but I do not see the starting/ pivot point for the front 19 inch radius nor for the door. Does anyone know or can anyone figure out what that pivot point should be?
Thanks in advance for your help.
Posted:
Wed Dec 13, 2006 1:01 pmby greglaw
19" down ...19" in.
Greg~
Posted:
Wed Dec 13, 2006 1:37 pmby Mary K
Here is my drawing I did. Just right click, save and print from your pc.
Hope it helps.
Mk
Posted:
Wed Dec 13, 2006 2:28 pmby War Eagle
I'm so dumb, now that I see it that was simple. Thanks guys and girls.
Posted:
Wed Dec 13, 2006 4:09 pmby Mary K
Hey, I did the same thing. Why do you think I did the drawing.
Mk
Posted:
Wed Dec 13, 2006 5:51 pmby mikeschn
Sorry... I thought everyone knew....
Mike...
Posted:
Thu Dec 14, 2006 12:02 pmby Mary K
mikeschn wrote:Sorry... I thought everyone knew....
Mike...
It's okay Mike, you can't do all for us. We have to learn to think about our build sometime, and not just follow the instructions.
That is where the FUN begins.
Mk
Posted:
Mon Jun 11, 2007 10:49 amby SaGR
LOL! I was sitting here last night pulling my hair out wondering this same thing.
Thanks Mk for the drawing. I was correct on the template but over thinking it in my head.
Posted:
Mon Jun 11, 2007 11:22 amby Model_A Bill
Hey, I must be dumb too. That drawing really helps when doing the top front radious but I STILL don't see where the pivot point is for the door radious.
I'm sure someone will be glad to point out my ignorence!!
Posted:
Mon Jun 11, 2007 11:23 amby SaGR
It'd be the same as the front, 19" from the edge of the door and 19" down.
(?)
Posted:
Mon Jun 11, 2007 2:27 pmby Mary K
Here ya go.. I added a curve in the bottom rear corner on my door.
Mk
Posted:
Mon Jun 11, 2007 2:32 pmby SaGR
So on yours the plot point is 19" down from the top of the door and 11" in from the leading edge of the door.
Gotcha
Posted:
Mon Jun 11, 2007 3:27 pmby Mary K
SaGR wrote:So on yours the plot point is 19" down from the top of the door and 11" in from the leading edge of the door.
Gotcha
11" one way...19 the other , I just put the dimension on the other side of the mark.
Confusing???
Mk
Posted:
Mon Jun 11, 2007 3:32 pmby SaGR
Looking at your drawing it's clear.
I was just trying to put it in "Engrish" for the next person that searches for it.
