Page 1 of 1

PostPosted: Thu Feb 22, 2007 5:44 am
by Classic Finn
Now that is a nice idea...Im working on a warped door at the moment..even though it straightend out by itself almost to the correct shape again... 8) 8)

Thanks for sharing that..

Classic Finn :thumbsup:

PostPosted: Thu Feb 22, 2007 9:13 am
by Outlaw
Is that a Guinness shirt you're wearing? Nothing like a Guinness and a fine cigar. Hey wait a minute, what are you drinking? :oops:

PostPosted: Fri Feb 23, 2007 3:15 am
by BrianB
My only concern with your design is that you removed so much material from what should be the structural part of your door. Would adding a little bit of insulation there really make a difference over just leaving it a solid piece of plywood with a hole for the window?

PostPosted: Fri Feb 23, 2007 10:55 am
by Nitetimes
I did pretty much the same thing, the only place I left much was the hinge and latch areas. Even filled it full of holes to light it up. Works fine.

Image