Teardrops n Tiny Travel Trailers

Now Im sitting here pondering upon a way to fix the ugly back floor where it meets the back trailer frame...

Suggestions anyone?



Classic Finn

hey fin. not sure how to fix that. all of your photos look good and looks like the build is coming along. but how come all of your photos have that white hue around them? is hard to see some detail in someof them.

Heikki, we tooka piece of scrap al sheet and cut a piece the width of the floor and about foot long(less I think) and bent it into a U and fitted it around the base/end of things...we bent it with a ho-made sheet metal brake but any sheet metal shop could bend it easily enough....
madjack

madjack wrote:Heikki, we tooka piece of scrap al sheet and cut a piece the width of the floor and about foot long(less I think) and bent it into a U and fitted it around the base/end of things...we bent it with a ho-made sheet metal brake but any sheet metal shop could bend it easily enough....
madjack

Okidoki Madjack that shall be done.. I went shopping for some stuff but couldnt find anything that wide to use for it..

Thanks

Classic Finn

diverguy wrote:hey fin. not sure how to fix that. all of your photos look good and looks like the build is coming along. but how come all of your photos have that white hue around them? is hard to see some detail in someof them.

Howdy Diver Guy..Thank You for the kind words .. That White Hue You can think of as frost. Its cold at night here in the Arctic and in the Arctic Skies Workshop .. Are there some specific photos you want to see especially and I,ll do my best to post them for you..

Classic Finn

PS Diverguy your tear looks very sharp ..sure do like the decor..

...a piece of al flashing or a piece of somethng similar(if not the same) as that diamond plate you have...or take your dimensions to a sheet metal shop and have them make it up out of whatever they have in stock that you like(copper, brass, al, titanium, chrome moly anodized marine grade stainless...or some such )
madjack

madjack wrote:...a piece of al flashing or a piece of somethng similar(if not the same) as that diamond plate you have...or take your dimensions to a sheet metal shop and have them make it up out of whatever they have in stock that you like(copper, brass, al, titanium, chrome moly anodized marine grade stainless...or some such )
madjack

Madjack you are a great instructor. Well you already new that .. That anodized marine grade stainles does bite.. I,ll check into it come sunrise..

Thank You
Classic Finn