Page 1 of 1

Rubber coated aluminum channel weatherstrip

PostPosted: Fri May 18, 2007 2:16 pm
by Airspeed
I saw a link to some rubber coated aluminum weatherstripping on here somewhere and I cant find it again! It was an aluminum 3/4"channel with a rubber coating and a rubber gasket attached. anyone know where I may have seen this? Thanks! Aaron

PostPosted: Fri May 18, 2007 2:36 pm
by Juneaudave
I think it might be Diverguy...try this link http://www.tnttt.com/viewtopic.php?t=15591&highlight=
:thinking: :thinking:

PostPosted: Fri May 18, 2007 6:48 pm
by madjack
...was it something on this page http://www.austinhardware.com/dept.asp?dept%5Fid=8 ............ 8)

PostPosted: Fri May 18, 2007 11:16 pm
by Airspeed
MadJack,That was close but the stuff I saw would go over the edge of 3/4" plywood and had a rubber gasket on top. I want to use it on the walls in my galley to trim the edges and seal the hatch.
Thanks! Aaron

PostPosted: Sat May 19, 2007 7:38 am
by BrwBier
Was it something from this page? they have stuff to fit over 3/4" edges.
http://www.mcmaster.com/
On the home page on the left side go to find products and type in 3342, that is the page number and their are 5 pages of edge trim.
Brwbier