Page 1 of 1

installing a drop down table/sink and other td questions

PostPosted: Thu Aug 30, 2007 11:01 pm
by Betty as in Boop
Hello,
I'm new to this and I am in the market for a td, hope to get one soon. (was considering an Eriba Puck but can't seem to find a decent one). I've done some research and need to stay light (tow vehicle is a new beetle). I'm looking at used and new tds. I would like to have one with a drop down table on the inside and have seen some on homemades, some of these also have sinks which I would like. First, I'm a little leery about buying a homemade so I am looking for advice about what to look out for. Second, I'm considering a Little Guy but was wondering if there is a drop down table that can be purchased to put in it or plans to make one for it. Also are sinks on the market, tips to install?

Thanks,
Betty

PostPosted: Fri Aug 31, 2007 7:37 am
by RAYVILLIAN
Betty
I use to have a 4 x 8 Little Guy and it would be a light enough pull for your Bettle but they are really small . I put in a sorta drop down table in ours by takeing the cabinets off of the bulkhead and putting them at the top of the front wall. Than I built a new bulkhead panel with a door in it that was hinged on the bottom with chains to hold it up for a table of sorts. This also gave me access to the lugage area with out going outside. I'll try to find some pics of it if I have them.
Gary

Just put a pic of the door/table and 2 of the small galley that I built for the Little Guy in my album hope this helps