Page 1 of 1
Offset
Posted:
Wed Jan 26, 2005 4:33 pmby TRAIL-OF-TEARS
Here is a dumb question but what is the typical offset for wheels used on a tear? I would like to use either factory Ford Escape wheels (to match the tow vehicle) or Some smoothies. I don't really want normal trailer wheels. Do I need 0 offset, + offset, or - offset? and how much offset do I need? Thanks all.
Posted:
Wed Jan 26, 2005 5:08 pmby emiller
Go to
http://www.wheelvintiques.com/ they have an diagram to measure your wheels and will help you with what you need.
Posted:
Wed Jan 26, 2005 5:47 pmby SteveH
Steve,
I'm using stock Jeep wheels, 15 X 7, and they are just right. If you want, I'll measure the back spacing?
Posted:
Thu Jan 27, 2005 10:01 amby TRAIL-OF-TEARS
Thanks emiller, nice site.
Steve that would be nice seeing as how we have the same axle. then I know I should be ok. Thanks
Posted:
Thu Jan 27, 2005 11:11 amby SteveH
Steve,
The backspacing on my wheels is 5" (I know, pretty W I D E wheels for a tear), measured from the outer most portion of the rim to the hub surface. Keep in mind my walls set in line with the outside of the frame.
Posted:
Thu Jan 27, 2005 5:50 pmby asianflava
The smoothies that I got have 3.75in backspacing, with the tire it is right at 4in. If you don't have your axle yet then, offset shouldn't be an issue. You can order the axle to fit the wheels.