Page 1 of 1
alumunum t-molding for 23/32 plywood????
Posted:
Mon Dec 17, 2007 7:02 pmby aquaholic14
I keep finding 3/4 t-molding for edging plywood, but cant seem to find the 23/32. Does anybody know where I can find some, or should just use the 3/4. Will the extra 1/16 cause a little lip on my ply??
thanks,
chad
Posted:
Mon Dec 17, 2007 10:39 pmby halfdome, Danny
Glue on a strip of plastic laminate (Formica/plam) on your 23/32" plywood to fill the gap. 
Danny
Posted:
Fri Dec 21, 2007 12:21 pmby Airspeed
You could just trim the T moulding down, it cuts easy on a tablesaw or bandsaw. Aaron
Posted:
Sat Dec 22, 2007 12:59 amby doug hodder
The difference is 1/32"...I'd just hit it with a good mill file to take it down, and a quick pass with some 400grit to smooth it. Just an idea. Doug
Posted:
Sat Dec 22, 2007 2:11 amby Nitetimes
doug hodder wrote:The difference is 1/32"...I'd just hit it with a good mill file to take it down, and a quick pass with some 400grit to smooth it. Just an idea. Doug
And angle grinder with an aluminum flapper disc on it will do both in one pass, quick too!!
