My Power Control Center
Posted: Sun Mar 27, 2005 12:44 amI finished my power control center and posted a picture in the Electrical Secrets area of the board. I made it out of an 1/8" anodized aluminum extrusion I had laying around.
I designed a simple panel in Visio, printed it out and hot lamenated it. I then cut it to size and used a hand mechanical punch to put the holes in the aluminum and printed panel.
Picked up the switches at Lowes, the 120vac 15a circuit breaker came out of an old power strip I had. 12vdc fuse holder from Radio Shack.
Total cost is well under $20.
Take a peek and let me know what I may be missing. I think I've got it right, but I don't want to over look anything... I'll be mounting it in the galley.
http://tnttt.com/viewtopic.php?t=2707
I designed a simple panel in Visio, printed it out and hot lamenated it. I then cut it to size and used a hand mechanical punch to put the holes in the aluminum and printed panel.
Picked up the switches at Lowes, the 120vac 15a circuit breaker came out of an old power strip I had. 12vdc fuse holder from Radio Shack.
Total cost is well under $20.
Take a peek and let me know what I may be missing. I think I've got it right, but I don't want to over look anything... I'll be mounting it in the galley.
http://tnttt.com/viewtopic.php?t=2707