Teardrops n Tiny Travel Trailers

This is what I have to work with, from outside of the 2x2 steel it's 4 ft, middle of tires is about 62 inches, from where the widest point of the v starts to the center of tire about 78 1/2, then another 55 1/2 to the rear, making a total of 134 from the v in front. I don't think I want anything wider then the middle of each tire, and cutting the sides isn't a problem, I'd rather leave the axle location where it is and cut the rear. I like the way the Grumman looks and am thinking of tweaking the size. Another point is the dropped floor. Storage or bigger entry? This is where I start. Any input would help.

Jeff,

You'll want to upload your photo to your album, before you try to post it in your message.

Click here for how to do it...

http://www.mikenchell.com/pichelp.html

Mike...

make sure you get all of the rust off -- sand blasting usually ain't too expensive

The rust looks worst then it is, it could use a good sand blasting which I'll have to get around to. This thing is a pig, lifting it by the tongue, it's already heavy. After looking at other profiles it would seem a kampmaster or a ken skill would fit it better. I would really have to load the back and keep the front as light as possible. Axle bushing is shot so that would be the first big hit. Found a direct replacement for a scotty that is 2000lbs and only about $250.