Teardrops n Tiny Travel Trailers

Got my trailer ready and the wood frame floor built . have sealed the bottom and are ready to bolt wood frame to trailer frame . Question is should i run some wire or pre drill any holes for wire later . i no it has to be done but do i do this now or later ??????


I have some pictures of my build in my personal gallery , you can view them in there as i dont no how to get the album thing to appear in my post

Norm

depends on your lights or electrical needs and the path you plan on taking with the wires. Some put them over the room or through the side walls. i think due to width requirements i have to have front lighted markers so i plan on running wires up to them. i was also planning on my reading lights at the front bulk head to run through the roof, but i am thinking of now running underneath and up the front.

It depends on your power needs are and where you need them .
Reading light / ex fan/110 power /galley power.
I ended up going through the walls with my 12v and through the frame with 110v and i had to rerough my 12v ex fan in the frame because i put a air nail through it. So sit down and draw out your plans so you can have an out if you need one
good luck with your build
and think it through
Dan