Teardrops n Tiny Travel Trailers

Found a company in Europe that sells Trim Moulding. Soft for easy bending. Website is here http://tacoeurope.com/cat--Trim-Moulding--trim.html They have other interesting parts as well.

A50-0273

Light Weight aluminum edge trim for tight radius bending. 6000 prime grade aluminum grade alloy.

Another term for it is - Transom Trim



A50-0273 Product Detail


Bulk Length Height Width Screws Finish
A50-0273TAL12D 12’ 5/8" 1/4" #5 TAL
Drilled and countersunk on 6" centers


Also this: http://tacoeurope.com/cat--Rigid-Vinyl- ... lding.html

Ah yes, 6000 series AL; referred to high formabilty in aircraft.

Ageless wrote:Ah yes, 6000 series AL; referred to high formabilty in aircraft.

So Is this good material to use then? What do I know

From that website is that other moulding good for use ?

Yep; at Boeing; used aa lot with forming compound contours as it is 'soft' and won't crack. Then it can be heat-treated to a T6 condition

Ageless wrote:Yep; at Boeing; used aa lot with forming compound contours as it is 'soft' and won't crack. Then it can be heat-treated to a T6 condition

Well All Beeeee. Learned somthing again in my high age

Ive been diggin deeper into this company via the website. And again I found this.

http://tacoeurope.com/item--13-16-x-9-1 ... -0326.html

Sooo is this also the soft bendable moulding. All that says 6000? If so what luck I have in finding this site.

However what is the normal size corner moulding you folks use there in the States? Is this too big maybe?

For those of you that are on this side of the Atlantic here is the contact info for the moulding and all.

Taco Europe by Zwaardvis
Van leeuwenhoekweg 22
5482 TK Schijndel
The Netherlands
+31 73 65 80 059 · Fax:+31 73 54 32 321