Page 1 of 1

Glue my stainless steel sides to plywood

PostPosted: Fri Feb 19, 2010 7:48 pm
by georgedombeck
Thinking of using construction adheasive. Yes no maybe. thanks, george

PostPosted: Fri Feb 19, 2010 8:14 pm
by JJKC
Most people on here just float it and use the trim to hold it on or indoor/outdoor carpet adhesive

PostPosted: Sat Feb 20, 2010 12:04 am
by Arne
I don't see any type of glue holding it... smooth metal to wood is extremely difficult....but if you find any, let us know.

PostPosted: Sat Feb 20, 2010 1:43 am
by Ward
George you wouldn't want to use the heavy duty construction adhesive if the SS is very thin, I would suggest either the spray adhesive as mentioned or in the same section as the const, adhesive will be mirror adhesive that will not be so thick. In other words you would not like the outcome of using a thick adhesive as it would be noticeable through the skin.

Also I would not soley rely on any adhesive alone. Hold it with trim as mentioned or use som SS screws.

Regards

PostPosted: Sat Feb 20, 2010 9:02 am
by planovet
JJKC wrote:Most people on here just float it and use the trim to hold it on or indoor/outdoor carpet adhesive


That's what I would do :thumbsup: