Bumper Opinions & Table Leg Ideas
Posted: Thu Jun 03, 2010 2:40 pmJust heard from our neighbor that finally a mutual friend is coming to visit us tomorrow morning to take measurements for the long planned bumper in the back. He only does stainless work. 
This is my idea about a bumper. But your input is always nice.
My idea is that a 50mm radius stainless pipe that has a right angle onto the sides another 50mm or even 80mm wich is plugged at the ends or capped. 50 millimeters = 1.96850394 inches
Simple and Clean straight bumper? What would your ideas be?
Here,s the rear pic of our tear.
Also this gentleman can do the bending of the piping for a nice table stand, a grill or dutch oven.
This is my idea about a bumper. But your input is always nice.
My idea is that a 50mm radius stainless pipe that has a right angle onto the sides another 50mm or even 80mm wich is plugged at the ends or capped. 50 millimeters = 1.96850394 inches
Simple and Clean straight bumper? What would your ideas be?
Here,s the rear pic of our tear.
Also this gentleman can do the bending of the piping for a nice table stand, a grill or dutch oven.
