Door Cutout Size?
Posted: Tue Jul 26, 2005 12:24 pmI'm getting ready to do the final cut on my doors. I am using a "T" molding (aluminium) to seal the doors. How much smaller should the doors be compared to the opening?
Raul
Teardrops n Tiny Travel Trailers
or t n ttt for short (tnttt.com)
https://www.tnttt.com/
Door Cutout Size?
Page 1 of 1
Posted: Tue Jul 26, 2005 12:24 pmPosted: Tue Jul 26, 2005 12:39 pm1/4" all around.
Raul
Raul
Posted: Tue Jul 26, 2005 4:07 pmralaco wrote:1/4" all around.
Raul
After the opening has been trimmed!
Kerry
Posted: Tue Jul 26, 2005 7:38 pmWell to cut my doors I just used a 1/4” Router Bit a door template and routed the doors and then trimmed them.
Raul
Raul
Posted: Tue Jul 26, 2005 7:44 pmHow thick are your doors. I'm talking about doors and openings that are 1 1/4" thick. You need a little space for the door trim and some more space for the door to clear the opening when opening and closing the door.
Kerry
Kerry
Posted: Wed Jul 27, 2005 10:00 amKerry
My doors are 3/4"
Raul
My doors are 3/4"
Raul
Posted: Wed Jul 27, 2005 11:13 amGerdo:
I sent to you a personal message about what Cubby's plans said about cutout door openings.
Raul
I sent to you a personal message about what Cubby's plans said about cutout door openings.
Raul
door size
Posted: Wed Jul 27, 2005 5:35 pmgerdo
i tried 1/4" all the way around and had lots of trouble...i have since gone to 3/8" all the way around and have had no trouble since...my door adges and door opening is trimmed with .032 aluminum and i use a t-mold on the door...my doors are a full 1 1/2" thick...
ellisdee9091
i tried 1/4" all the way around and had lots of trouble...i have since gone to 3/8" all the way around and have had no trouble since...my door adges and door opening is trimmed with .032 aluminum and i use a t-mold on the door...my doors are a full 1 1/2" thick...
ellisdee9091