Teardrops n Tiny Travel Trailers

Well its been a while coming but I finally got the film developed,, here are the results,,

Madjack,,,here da pics>>>>

http://pg.photos.yahoo.com/ph/abc187chi ... as,1%3af,0

what ya think??

chipper

Looking good Chip. But I thought you had a tear. Now I'm confused.

Have a good day.

Gage,, this is Number 2,, sold my other one, so I am Tearless,,,,

thanks fer the thumbs up

chipper

Look'in good, Chip.

That frame shure looks "tall"...what material is made from?

Steve the frame is 3" light gauge channel

Looks good Chip. If the northern Alabama get together comes about, hope to see you and the newest addition there.

Chip,

Sorry, I just realized that I looked at the pics and forgot comment on them earlier.

Looking good! Nice Job!

I like the look of the wheels. Are you going to leave the sides wood? I think it looks good like it is.

Hey Chipper,

Lookin good. I like the 3" channel for the frame, been thinking that's the way to go for several reasons. If there is a TD #2 in my future, think I'll do that, but I gotta finish the 1st one..


Steve in St Augustine

luuuuukin' goood there chipper...be out hawkin' that PJ in no time .................................................

Chip,
Looks good I see what you mean about the boat tralier. Mine looks simular. It's made out of 2" x 3" tube with 3" channel crossbars. What size is yours going to be.

very nice anxious to see the final result.

Steve D (HVM) I am gonna be ready for Bama one way or the other,, My target is to be ready to go to Little Talbout in Februrary,, It may not be 100% but what the heck its going,,,

warpony,, Liked the way the wheels came together too, thanks,, Right now the outside is planned for a two toned woody, top now thats a different deal,,, what I want and what I finally come up with may be different,,time and money will tell,,,

Powder the rear of he trailer is actually higher than the front, almost a reverse tear shapeIt could go either way but I was trying for a very low frontal area and it actually is eliptical,, gives me a little more room for junk in da trunk,, so to speak,,,

Madjack,,, there will definately be a coming out party for the "Pickled Inn"

Sonetpro,,, the frame without tongue is 41"x71" plus bolt on tongue adds another 50 or so inches,,the tear is a 4x8x4 light weight minimal frill unit, the rolling frame complete with chains and temp lights weighed in at 248 lbs,, I am trying to make it light but now to the extreme.

I appreciate the good comments from everybody,,,

bar is open, drinks on my tab

chipper

Chip, I noticed three bottles in your tear. Looked like one Titebond and one Gorilla, but what was the other?

Bledsoe,,,,,I woundered if many would catch the added accessory in that picture,,, good eye thar or just another con-e-suer of teardrop consumables,,,,

chipper

p/s that would be Ezera Brooks