Teardrops n Tiny Travel Trailers

...we finally finished the lower galley cabinets and battery box today...even though we had a monsoon blowing thru...also had a really nice visit with board member Charles Ippes, his wife and their "legal" advisor...enjoyed the visit charles...there is a step by step pictorial at my"WWW" button...click on galley 2...let me know what ya think
galley 2 linky/clicky
madjack

Nice,
Is the cut out for a small sink?
if it is where did ya get it?

Looks great Jack!!! especially since I know all the scoop on what's behind the wainscotting!! and for any of you builders out there...give a tour to potential builders and others whenever you can...just make sure they have enough transmission to get them there and back...sorry Dan....just giving you a bad time...Doug

Looking good Madjack. You're almost ready to go camping!

Mike...

kiltedhiker wrote:Nice,
Is the cut out for a small sink?
if it is where did ya get it?

the cutout is for the sink...a SS steam table tray...I guess I coulda put it in place for the pic .........
p.s the tray came from a restaraunt supply house, is 6x12(??)x6 deep...cost less than 10bucks

Very Good!!
Didnt think about that
I keep that in mind!

mikeschn wrote:Looking good Madjack. You're almost ready to go camping!

Mike...

we also did a final fitting on the hatch so as soon as we get some more gorilla glue we can skin it and we will be ready to apply the Al skin...we aslo prebent a bunch of the trim...gettin' close, gotta be ready for Beaver's Bend
madjack

Looks good, Madjack.

Nawwice!

That center panel and its cam-lock is clever - it looks like an idea that you've refined in your head a good few times before actually making it!

Andrew

Hey MadJack that really looks good.
Like Andrew said your cam lock on the panel must have taken quite a bit of thought. I like it, yep really like it..

we had not thought a lot about it till it came time to fasten the center panel someway and we realized that you would haveta get into that area regularly and screws weren't acceptable...suddenly lightning struck, the glue pot spilled and my build partner said "wadda 'bout some kinda cam lock"...2 or 3 attempts later and what you see was born...along with the tab at the bottom of the panel it works reall well...by the way the tab and lock catch behind the rails the sliders sit in
madjack

Looking good, is that a Pontiac Aztec in the back ground and do you have the tent attachment for it.

yes it is an Aztek and it is an excellent if somewhat strang looking car/truck/SUV and no we didn't get the tent attachment..already had a couple of tents, didn't want another, applied the thousand bucks to the down payment
madjack

MadJack - Is your battery box vented?