Teardrops n Tiny Travel Trailers

Router bit
Needing a 1-1/4” guide bushing (Porter Cable 42021) for Tony Latham’s interior galley lip (p77). It appears this is no longer available, and we can’t seem to find an equivalent from other companies.
Any ideas? TIA

Try this place https://www.mlcswoodworking.com/?gclid= ... -xEALw_wcB

Danny,
it’s used to cut the radius on the hatch lip tongue for water tight integrity following Tony’s book.
I will the say it works. I took my TD through a coin op car wash today to get the crud off on this trip I’m on and not a drop of water in the galley.

Pretty sure I bought mine through Amazon in June.

I think this may be the one. Look in the Q and A someone gives the description as 1 1/4”

https://www.amazon.com/PORTER-CABLE-420 ... 30&sr=8-24

Try cut and pasting this in the Amazon search bar.

PORTER-CABLE 42048 Template Guide

I made this edit to the book last week because of this issue:

For the lip, install a 1-1/4” guide bushing (Porter Cable 42021) in the router base plate and a 1/4” spiral up-cut bit. (Note: This bushing is hard to find. You can use a 1” bushing but the hatch spacer –when you get to that point– needs to be 1/8” wider.)

Tony

Can you make an MDF template and use a top bearing flush trim bit.

JasenC wrote:Can you make an MDF template and use a top bearing flush trim bit.

Sure.

Tony


Sent from my iPad using Tapatalk