Fender input needed

[JasenC]

Looking for a little input from the group.
Not to keen with the fender brackets on the NT trailer, kind of need to take a hammer to them to get the fenders to sit level and well, they are just kind of cheap and ugly



I could fab up something a bit cleaner/stronger but seeing I'm building out over the fenders I'm thinking of ditching the brackets and bolting the fenders to the bottom of the floor with some 1/4" stand off's so they aren't in direct contact so things can dry out under there and not rust out the fenders. Figure I can put in some Tee-nuts before closing in the floor, pump the holes full of silicon as I run in the bolts to seal them up.

I'm open to suggestions and brilliant ideas.

[tony.latham]

My fenders are supported with butt-welded tubing that's attached to the sides of the chassis frame. The tubing is on the inside of the fender.



If I were to do it over, I'd weld the 1" tubing under the frame. I don't know if you have room to do that?

Tony

[Sparksalot]

Mine are bolt on, but using brackets underneath. I think I found them at Tractor Supply.

[JasenC]

Both of those set ups are a lot nicer.