I was wondering if anyone in the group that had cad experience would be willing to try and turn my ideas into a 3D image?
I am looking for a program to try myself but Know the learning curve will be long.
Some of the things I want are;
1. Camp Inn 550 profile (no 90deg. corners)
2. 5' wide 10' long
3. Tall enough (but not over 5') to have the door profiles of MJ's alligator tear
4. Deep tounge box with tophatch like Danny and Jane's Halfdome and the battery at the very front center to allow some storage accessable from the inside.
5. Window shaker mounted in the rear bulkhead vented under the trailer.
6. Galley design like Danny and Jane's Halfdome with the pull out outback oven and a pull out ice chest tray for one of the stainless colemans
7. Rear hatch that goes all the way down into the bottom radius.
8. A 20lb. propane bottle somewhere? tounge i guess
9. 15" tires fenders may be a challenge
10. Interior the only thing I'm very sure of here is a flip down dvd play & a fantastic vent
and now for the fun; a hinge in each galley side wall even with the rear of the bulkhead that would allow them to swing out 90 deg. and have a shelf or counter top that was attached to it. (would have to be slightly higher than the main counter) as it would need to be supported by a sidewall from the floor.