doug hodder wrote:I'm busy laying out my profile on a standy also. Tough to fit it all in and make something that will roll in the garage, you've got a lot of design ideas I like. Just a thought, have you considered easing the hard break on the front radius where it turns flat to sort of match the rear? None of my business, just my opinion. Doug
There are a lot of challenges doing a standy, expecially fitting one into the garage, packaging everything in, and still not being too much wider than the tow vehicle.
I've got two thread going, that have gone quiet, because we haven't stumbled on the right answers yet... the standy thread, and the puffin standy thread.
Maybe you and Rich have the answers we've been looking for?
Mike...