Hi everybody,
I made a little sawdust today, cutting out the framing pieces for the left side. I laid them out over my drawing to check for fit and accuracy. Before I glue this up, I need to stitch an extension piece to the plywood to get my 10 foot length. I'm going to join under the frame piece for the aft bulkhead, so it can back up the joint. then I'll have to add about 3 feet on that to get to 10 feet.
Getting ready to make router dust takes a lot of attention and detail so you can get everything done in one setup. I've spent the last couple of days reviewing and revising my drawing. I'll put up the latest version DXF after I get the first side done.