HITCH LENGHT

[MARVIN THOMPSON]

HI ALL JUST FINISHED A HITCH FOR MY SCORN XB. IS 12INCHS FROM THE TUBE PIN TO THE BALL CENTER IS THAT TO LONG.COMES OUT FOR ABOUT 8 THEN TURNS UP AT 35 DEGREES TO THE BALL. TD TONGUE WEIGHT NOT BAD I CANT PICK UP.

[bobhenry]

Our 2005 XB hauled Chubby 800 miles 1st outing. He weighs in at 975 "my best quess" . The hitch should have the rating on the reciever. I am guessing this it a stealth hitch and receiver. Most folks on this forum are scratching their heads trying to figure out what we are talking about. I am assuming that your ball mount is almost a big "u" with a flat for the ball. This ball mount slides in from the bottom into the receiver then pins. I had never seen one before I bought this Scion. When the ball mount is remover there is NO hint that a trailer hitch is installed , hince Stealth hitch! Since the reciever and ball mount are supplied as a set I as confident that as long as I did not exceed the recievers total capacity I was fine.

[Dale M.]

Pictures?

Dale

[bobhenry]

http://www.draw-tite.net/pdf/N28501.pdf

Looked all over before I found one !

Rated for 200 tongue 2000 total behind a 1400 cc Xb

[mikeschn]

Marvin,

A picture might help... I'll measure my hitch in a bit, the one that put a dent into the side of my car...

Mike...

IS 12INCHS FROM THE TUBE PIN TO THE BALL CENTER IS THAT TO LONG.

[MARVIN THOMPSON]

ITS A FACTORY HITCH I CUT DOWN. 1&1/4 TUBE JUST COMES STRAIGHT BACK 8 INCH THEN TURNS UP 4 INCH ,THEN A BALL PLATE. SORRY NO CAMERA.