Static Toe-In Angle Question on Hubs

[ssuuki19]

1 by six pressure treated decking board, its great for the job, all the wood is clamped to the frame with 10 standard u-bolts (*plus 4 bolts in the frame)

image4.jpg (103.02 KiB) Viewed 782 times

brand new same Flexiride 930lb adjustable spline half axles, same wheel spacer adapters from the original stripped down version

image5.jpg (71.42 KiB) Viewed 782 times

wires on the tongue still to be fished into the junction box to fully clean up the look

image6.jpg (77.72 KiB) Viewed 782 times

Test two

[ssuuki19]

my design approach is there to be seen - hopefully simple

image7.jpg (74.96 KiB) Viewed 781 times

won't hold much, but that box is about 4 foot four by 8 foot nine so she'll fit some plywood and osb and whatnot without pinching the fingers

image8.jpg (81.29 KiB) Viewed 781 times

its light its less than three hundred pounds for sure, and remember i can take these 10 standard u-bolts & 4 lag bolts off, drop the cabin back on & 8 lag bolts and go for a road trip ;) until then.. the barn fenced stripped down aluminum half axxed laydee is back on the road logging miles ;)

image9.jpg (123.88 KiB) Viewed 781 times

Test thrice

[ssuuki19]

Its been a while... ummm.. uhhhh... the damn trailer still trails. It works. I never even greased the hubs. To put book-ends on this post perhaps I should take those darn warped half axles and make that darn ATV trailer ... at some point. But just for now, she still tows, she does work, because I don't own a pickup truck so I need this 4 1/2 by 9 trailer. Over and out for now..