subterran wrote:Now, getting a bit more technical: the simple controller I linked above only has connections for "Panel" and "Battery", where most controllers also have a "load" connection as well. What this is for is to connect to a fusebox (suggested) then to the devices that you want to run. (except for high-drain devices, like a big inverter - you would just connect the big inverter directly to the battery) The reason is that the 'Load' connection also regulates the voltage going to your devices to keep it steady, whereas the cheap one above will be outputting up to 14.5 volts when the sun is out.
No, that's not quite right. The voltage at the load controller is the same as the output of the solar controller to the battery, which will vary up to 14.4 V for a Sunsaver on a flooded battery. The load controller is used to disconnect the load from the battery at a preset voltage (11.5 volts for a Sunsaver) so you don't accidentally drain the battery too much and ruin it. The load disconnect typically has the same current rating as the controller so its usually too small for an RV. 6 to 10 amps is also pretty small for a teardrop. Gee, can you tell I kind of like Sunsaver controllers?

Bruce