How to make a bed raise to the ceiling solved....

I have been reading this forum and searching the intenet to find a solution other than the $2000 kits. And i believe i have finally figured it out , I will post pics once it is complete but the solution is as follows . My rails are garage door track 4 pieces cut to fit the height i need with room for pulleys overtop of the rails. The bed moves up and down on the #1 garage door roller bolet to a frame to fit the trailer size i made mine out of 2x2 angle with 5/8 plywood as a bottom. The #1 pulley is where the cable would attatch on a garage door and i will have 4 cables going to the top of the rails to pulleys and going back down the wall through electrical conduit, the cable will go beneath the trailer and will connect to winch at some poing much like a popup trailer lifting mechanism. I plan on making it electric with a manuall backup in case the winch goes bad or something. I didnt have the option of fold up bunks since i plan on hauling two motorcycle in it and i need the full width of the trailer. With this setup i will be able to make 2 levels to lower the bed to 1 right above the motorcycle to sleep on the side of the road if needed and be able to lower it to normal height when camping and the motorcycles are out of the trailer.
The is a 7x12 cargo trailer with a combo toilet/shower and kitchen . I promise pics will come , it has been a long project but its not finished to the point i want to share it
The is a 7x12 cargo trailer with a combo toilet/shower and kitchen . I promise pics will come , it has been a long project but its not finished to the point i want to share it
