Side table by request..

[rainjer]

A couple people have asked about my stove side table so here it is. This is a prototype. I plan on making another on that is a little bigger. The design is base on a Coleman Chef table I saw at the ICCC convention.



It is designed to hang from the side of the stove.


This one is made from a piece of formica, 1/8" plywood and some 1/2" aluminum angle.


It is all riveted together.


Jeremy

[Justin & Katy]

[TLC]

Is there room to store the table inside the stove when in transit? Nice job by the way.
Tom

[rainjer]

Is there room to store the table inside the stove when in transit? Nice job by the way.
Tom

Yes. It fits between the burners under the grate.

Jeremy

[rainjer]

So here is the tray I picked up from another collector that came in the mail today.

I had to make a few mods to get it to fit my Sears stove.

I had to trim the top tabs on the stove side, move the brackets that hold the rod and drill 2 hole on each side of the stove for the rod to go in.

Here both at the same time.


I think I am going to mount a couple S-hooks in the one I made to hang pot holders & utensils.

Jeremy