One more line

[twisted lines]

Last one, because it told me only 3 pictures!
Have the wheelbase set now near finished with the frame.
Now it's built to fit instead of as drawn.

[twisted lines]

After cutting 2" off the back and tapering it to the front,
This is where the difference shows up! (The piece that's too tall with a pencil line)
Little worried about a drip edge.
Sides will be the same angle in, as the top that's marked comes down.

Tail.jpg (20.24 KiB) Viewed 199 times

[twisted lines]

Trimmed both rear sides, Think Ill like it.
And started the back of the Frame / Bumper;
Need's leveled, either the tape will hold it or not

[twisted lines]

Spent two days cutting, tweeking 1 tube a little bit in two directions,
because eyeballed wasn't close enough!
And it's for Alignment.
Second picture shows the rear bumper tacked on.

[twisted lines]

A few day's ago I stopped and Naaaa...

[twisted lines]

Just checking and without a tire it looks like the opening is too big,
so, I put one on.
Now to Back to removable mounts