One more line

[twisted lines]

Top end of the line moved again

[twisted lines]

2" Fender flair's add up to 79"

[twisted lines]

Two days and two little router bits latter (Hinge supports)

hinge blocks.jpg (45.59 KiB) Viewed 1087 times

clip.JPG (71.26 KiB) Viewed 1086 times

[twisted lines]

Setting up and cutting that line .
This side my anderson plugs unplugged while cutting. (Good side)

Ready.jpg (84.08 KiB) Viewed 1053 times

Looking at the good side.

Good side.jpg (56.31 KiB) Viewed 1053 times

Second side slid on the floor while pulling the wire

Now I can forget it, and adjust as needed

[twisted lines]

Now I have traced the line from the side to the flat side on the top;
Try to figure it out? (Radius)
Or try & make a hot wire to cut it

[Pmullen503]

I've found a flush cut saw useful for trimming foam flush with another surface. I always but a piece of cardboard on top of the piece I'm cutting flush to to protect it from the blade. Plus, it leaves a lip on the trimmed piece so I can sand it truly flush to the other piece.

Easier, and less risky than trying to hot wire it.

[twisted lines]

I've found a flush cut saw useful for trimming foam flush with another surface. I always but a piece of cardboard on top of the piece I'm cutting flush to to protect it from the blade. Plus, it leaves a lip on the trimmed piece so I can sand it truly flush to the other piece.

Easier, and less risky than trying to hot wire it.

Thanks for sharing!
May be the only tool; I know where it is.
I Now have tried it & Like it.

[twisted lines]

centerline of my trailer on a 10" lift and I can only look at pictures

10 in lift.jpg (106.47 KiB) Viewed 893 times

First test involved smoke

[twisted lines]

Got the lift to move try 2.
Found this takes 7 days and matches something.

Nose.jpg (67.79 KiB) Viewed 833 times

wall.jpg (54.93 KiB) Viewed 833 times

Shoe.jpg (47.67 KiB) Viewed 833 times

[twisted lines]

80 today; Winter tonight

[twisted lines]

Trimming, holding, measuring, and cleaning but not enough, shtuff is everywhere
Even threw in a 2" piece of gray!

[twisted lines]

House work sucks

Trying to find a convenient place, This time I have 5 tables under it
but enough length to put the back together; and some spindals!

[twisted lines]

New Photo sizer

[twisted lines]

Trailer is smaller (Broke it)
I guess the pile is getting Bigger.
And my new to me, welder works on 110.
220 Cord went POW guess I may open that up today!
Just The Plaz plug
Two screws touched unpluging fixed that, Glad I wear gloves

Stand.jpg (74.85 KiB) Viewed 115 times

Plug.jpg (48.79 KiB) Viewed 48 times