Aluminium composites

[Sheddie]

(are far away from Zeeland ? )

Yes, about 300 km from zeeland, so i'd think quite a drive. You're welcome to take a look though (old Zeeland Sheddie, not that new one of you )

Yes, I am a long way from Zeeland, and I might get a bit wet if I tried to drive from here to there.

[1TallTXn]

For those of you that have used Aluminum composite, what did you use for framing underneath? Wood? Aluminum?
What was the spacing on the vertical spars? Any horizontal spars? (speaking for the walls here)
Thanks!

[Jack Olsen]

My plan is to use very minimal framing. I'm thinking about aluminum 1" square tubing along the roof line where the walls meet the roof. I will use L-stock to hold the floor. But the composite panels adhered into a monocoque should be stronger than any any fastener-affixed wood frame could be. I'll use structural adhesive and make sure there is a continuous bond wherever two panels meet.

This is my tiny mock-up, showing curved aluminum junction framing and a curved top to the lunch-box-size sample.



The floor is two layers of corrugated plastic.

[1TallTXn]

My plan is to use very minimal framing. I'm thinking about aluminum 1" square tubing along the roof line where the walls meet the roof. I will use L-stock to hold the floor. But the composite panels adhered into a monocoque should be stronger than any any fastener-affixed wood frame could be. I'll use structural adhesive and make sure there is a continuous bond wherever two panels meet.

This is my tiny mock-up, showing curved aluminum junction framing and a curved top to the lunch-box-size sample.



The floor is two layers of corrugated plastic.

I like it!
Going that route, the framing can be very minimal. Thus cheaper, and even lighter.

I'll need a bit more (I think) around windows/doors and since I want to insulate, it'll need an interior side to the wall.

Thanks for tickling my thinker!