MarcInBoise wrote:tony.latham wrote:MarcInBoise wrote:Success!!! Denco has 4x8 painted that they will sell me. It's slightly more than I had anticipated, but not bad. Beggars can't be choosers!
Now to find the 5' wide mill finish or anodized for the top & hatch. They carry nothing in 5' and I don't want to deal with seams.
Marc
Marc:
If I can get 5' wind Salmon, you can get it in Boise.
I call up CDA metals in Missoula (HQ in CDA Idaho). The make a run down here once a week to the local steel store and deliver it to me for $10. Somebody carries it in Boise.
T
Thanks Tony, I'll look them up and give them a call. I'm getting really frustrated here... I've been to 3 RV repair places that all say "yea, we can order that from Interstate RV Metals in Portland" then tell me it will cost double for shipping.
If worse comes to worst, I'll hit you up for the name of your local steel store and have them order for me, then take a day off work and drive up to Salmon to pick it up. I'll still save a ton on shipping.
Hit up the places in Boise that sell sheet steel. I see O'Neal Flat Rolled Metals has the following in Caldwell:
Mill finish Aluminum 3003 H14 .032-.063
Mill finish Aluminum 5052 H32 .032-.250
Painted Aluminum 3105 .029-.050
Aluminum Tread 3003 .045-.125
Anodized Aluminum
T