Aluminum Skin Question

Finishes, paints and coatings

Aluminum Skin Question

Postby KendaldaCosta » Fri Dec 22, 2017 1:30 pm

I planned to do a woody with sandwich walls (3/4" centre with 1/8" inside and 1/4" outside) but now I'm tossing around the idea of doing an aluminum skin. If I go that route, do I still need an exterior sheet of plywood before applying the aluminum skin or can I just apply the aluminum to the middle layer?
Kendal
KendaldaCosta
Teardrop Builder
 
Posts: 41
Images: 7
Joined: Tue Nov 07, 2017 7:00 pm
Location: Edmonton, Alberta, Canada

Re: Aluminum Skin Question

Postby dogpound101 » Sat Dec 23, 2017 8:41 am

KendaldaCosta wrote:I planned to do a woody with sandwich walls (3/4" centre with 1/8" inside and 1/4" outside) but now I'm tossing around the idea of doing an aluminum skin. If I go that route, do I still need an exterior sheet of plywood before applying the aluminum skin or can I just apply the aluminum to the middle layer?
.

Wasn't the purpose on middle layer to cut out and insulate??


Sent from my iPhone using Tapatalk
Doug
User avatar
dogpound101
Teardrop Builder
 
Posts: 31
Images: 1
Joined: Mon Mar 30, 2015 3:04 pm

Re: Aluminum Skin Question

Postby dmdc411 » Wed Dec 27, 2017 10:14 am

I used 3/8" outside, 5mm luan on the inside, with 3/4" framing for doors & windows as well as perimeter blocking. I filled all the voids with glued in place high density foam sheeting. Then covered it with aluminum sheeting. I used 1/8" for the ceiling. It's fine for interior I would think. Exterior as a backer for aluminum, think you'd still want some strehgth. 1/4" or 3/8" at most. I used plytanium from Home Depot. Glued everything, no matter what, the insulation to! Good luck!

Sent from my SAMSUNG-SM-G870A using Tapatalk
User avatar
dmdc411
Teardrop Master
 
Posts: 258
Joined: Wed Feb 02, 2011 1:39 am
Location: Nfld, Minn
Top

Re: Aluminum Skin Question

Postby tony.latham » Wed Dec 27, 2017 2:16 pm

KendaldaCosta wrote:I planned to do a woody with sandwich walls (3/4" centre with 1/8" inside and 1/4" outside) but now I'm tossing around the idea of doing an aluminum skin. If I go that route, do I still need an exterior sheet of plywood before applying the aluminum skin or can I just apply the aluminum to the middle layer?


It's my opinion that it needs to be closed in. There's a chance that water could get under the skin. (I seal the exterior plywood with epoxy. A couple of slathered on layers of The Mix will probably work as well.) I think if you didn't cover the outside of the wall with plywood, and water managed to get under the aluminum, it could be a serious problem.

I use 1/4" plywood subfloor for my skins. It's better and cheaper than 1/4" ACX plywood.

Tony
User avatar
tony.latham
Gold Donating Member
 
Posts: 7011
Images: 17
Joined: Mon Jul 08, 2013 4:03 pm
Location: Middle of Idaho on the edge of nowhere
Top


Return to Skinning secrets

Who is online

Users browsing this forum: No registered users and 3 guests