scad-about profile
Posted:
Wed Jan 02, 2008 10:04 pmby Aaron Coffee
Does anyone have a measured profile for a scad-about? Trying to decide between a Rimple and a Scad-about profile for my next build(or some combination of the two).
Thanks
Re: scad-about profile
Posted:
Thu Jan 03, 2008 4:43 amby bobhenry
Aaron Coffee wrote:Does anyone have a measured profile for a scad-about? Trying to decide between a Rimple and a Scad-about profile for my next build(or some combination of the two).
Thanks
http://www.geocities.com/kartvines/SCAD-A-BOUT.html Best I could do! Hope it helps.
BOB
Posted:
Thu Jan 03, 2008 10:35 amby angib
I think the Scad-a-bout is pretty simple - a 24" radius at the the font and a 36" radius at the back, judging by eye.
Andrew
Posted:
Thu Jan 03, 2008 2:22 pmby bobhenry
Posted:
Thu Jan 03, 2008 6:23 pmby Aaron Coffee
Thanks,
I was thinking of doing just opposite of what angib said and doing a 36" radius in front and a 24" in back. I need the hatch to open at the tallest part as I am planning on building to haul a scooter inside. Don't have any cad programs, but may make a full size cardboard mockup. Thinking of going 5 wide 5 tall by 9.5 to 10 long.
Thanks
Posted:
Thu Jan 03, 2008 8:04 pmby bobhenry
Put a spoiler on it and give it a square butt. My next (Oh God not again) build.
Posted:
Fri Feb 08, 2008 8:07 amby GPW
Sorta' like the Hummer TD...
